Documentation: Census 1960 (US, County & State)
you are here: choose a survey survey document chapter
Publisher: U.S. Census Bureau
Document: Inmates of Institutions (Volume II, Part VIII - Subject Reports)
citation:
U.S. Bureau of the Census. U.S. Census of Population: 1960. Subject Reports, Inmates of Institutions. Final Report PC(2)-8A. U.S. Government Printing Office, Washington, D.C. 1963.
Inmates of Institutions (Volume II, Part VIII - Subject Reports)
Sample Design and Sampling Variability
Sample Design
For persons in housing units at the time of the 1960 Census, the sampling unit was the housing unit and all its occupants; for persons in group quarters, it was the person. In each institution and other type of group quarters, the sample consisted of every fourth person in the order listed.

Although the sampling procedure did not automatically insure an exact 25-percent sample of persons in each group quarters, the Sample Design was unbiased if carried through according to instructions; and, generally, for large areas the deviation from 25 percent was found to be quite small. Biases may have arisen, however, when the enumerator failed to follow his listing and sampling instructions exactly.
Ratio Estimation
The statistics based on the sample of the 1960 Census returns are estimates that have been developed through the use of a Ratio Estimation procedure. This procedure was carried out for each of 44 groups of persons in each of the smallest areas for which sample data are published.1 (For a more complete discussion of the Ratio Estimation procedure, see 1960 Census of Population, Volume I, Characteristics of the Population, Part 1, United States Summary.)
These ratio estimates achieve some of the gains of stratification in the selection of the sample, with the strata being the groups for which separate ratio estimates are computed. The net effect is a reduction in the sampling error and bias of most statistics below what would be obtained by weighting the results of the 25-percent sample by a uniform factor of four. The reduction in sampling error is trivial for some items and substantial for others. A by-product of this estimation procedure, in General, is that estimates for this sample are consistent with the complete count with respect to the total population and for the subdivisions used as groups in the estimation procedure.

Footnote:
1 Estimates of characteristics from the sample for a given area are produced using the formula


Where x' is the estimate of the characteristic for the area obtained through the use of the Ratio Estimation procedure,
xi is the count of sample persons with the characteristic for the area in one (i) of the 44 groups,
yi is the count of all sample persons for the area in the same one of the 44 groups, and
Yi is the count of persons in the complete count for the area in the same one of the 44 groups.

Sampling Variability
The figures from the 25-percent sample tabulations are subject to Sampling Variability, which can be estimated roughly from the standard errors shown in tables B and C. These tables2do not reflect the effect of response variance, processing variance, or bias arising in the collection, processing, and estimation steps. Estimates of the magnitude of some of these factors in the total error are being evaluated and will be published at a later date. The chances are about 2 out of 3 that the difference due to Sampling Variability between an estimate and the figure that would have been obtained from a complete count of the population is less than the standard error. The chances are about 19 out of 20 that the difference is less than twice the standard error and about 99 out of 100 that it is less than 2£ times the standard error. The, amount by which the estimated standard error must be multiplied to obtain other odds deemed more appropriate can be found in most statistical text books.

Table B. Rough Approximation to Standard Error of Estimated Number
(Range of 2 chances oat of 3)

Estimated number Standard error
50 10
100 20
250 30
500 40
1,000 50
2,500 90
5,000 120
10,000 170
15,000 210
25,000 270
50,000 390


Table C. Rough Approximation to Standard Error of Estimated Percentage

Estimated percentage Base of percentage
500 1,000 2,500 10,000 25,000 100,000
2 or 98 1.1 0.8 0.4 0.3 0.1 0.1
5 or 95 1.7 1.1 0.7 0.4 0.2 0.1
10 or 90 2.1 1.6 1.0 0.6 0.3 0.2
25 or 75 2.7 2.0 1.3 0.7 0.4 0.2
50 3.1 2.5 1.9 0.8 0.5 0.3


Table B shows rough approximations to standard errors of estimated numbers up to 50,000. The relative sampling errors of larger estimated numbers are somewhat smaller than for 50,000. For estimated numbers above 50,000, however, the nonsampling errors, e.g., response errors and processing errors may have an increasingly important effect on the total error. Table C shows rough standard errors of data in the form of percentages. Linear interpolation in tables B and C will provide approximate results that are satisfactory for most purposes.

For a discussion of the Sampling Variability of medians and means and of the method for obtaining standard errors of differences between two estimates, see 1960 Census of Population, Volume I, Characteristics of the Population, Part 1, United States Summary.

Illustration: Table 3 shows that there were 40,792 white female inmates 60 to 64 years old in the United States in 1960. For an estimate of 40,792, table B shows that a rough approximation to the standard error is 346, which means that the chances are about 2 out of 3 that the results of a complete count would not differ by more than 346 from this estimated 40,792. It also follows that there is only about 1 chance in 100 that a complete-census result would differ by as much as 865, that is, by about 2 ½ times the number estimated from table B.

Footnote:
2 These estimates of Sampling Variability are based on partial information oil variances calculated from a sample of the 1960 Census results. Further estimates are being calculated and will be made available at a later date.